Hi there, I have factory reset the DS-7716NI-SP and it's asking for a default password but 12345 or the one that I set is not working. Any ideas? The firmware that I am using is V3.4.3 build 160811. UK edition. Cheers, Epipen. Unplug the laptop network cable, disable WiFi and all anti-Virus and Windows firewalls to eliminate possible problems, then plug the laptop cable into the PoE switch and set the laptop IP address to 192.0.0.128, which should be in the same subnet as the factory default camera IP address of 192.0.0.64. hikkavision recovery tool for Windows and Linux, ip caneras password, reset ip camera password, recover password, ip camera passwords, hikvision passwords. C 22 28. hikavision-recover Public. hikvision ipcameras ip camera password reset offline tool for encrypt.xml support hikkvision reset code fro admin. C 9 3. Here are the steps that I hope will work to extract the flash partition segment that holds the NVR cameras configuration, the passwords for which are very likely to be the NVR password also. Start PuTTY. Keep Control-U pressed until it auto-repeats and power on the NVR. You should get a screen like this : The problem is that hikvision cameras are password protected too, so even if you replace the NVR the cameras won't connect to the new one. So if you replace/update the system, the only thing you can use is the wiring from the old system. Hikvision themselves might be able to help you, but you'll probably have to run an ethernet cable from the Here is how to reset the password so you don't get put on hold for 30 min by Tech Support: 1. Make sure to have a computer on-site and have the SADP tool software installed beforehand. 2. Open up .

reset password ip camera hikvision